Lead times for Prolam engineered timber products vary depending on the product type and current manufacturing schedules.

For the most up-to-date information, refer to the lead times page on the Prolam website.
For urgent orders, contact the Prolam team directly. 

Yes, it is important to coat Prolam exposed timber before installation to prevent moisture ingress and preserve aesthetics and durability. This also applies to any cut ends or joins.

Prolam glulam can be stained using an oil or painted using an enamel paint. These products must have an LRV rating over 45%.

You can view our coating requirements and recommendations here.

Yes. Prolam glue laminated timber can be painted or stained to match the aesthetic. In fact, any exposed timber must be painted or stained with an oil based coating to preserve aesthetics and durability. This is optional for Prolam glulam timber used in internal applications.

View coating requirements here.

Prolam glulam beams and posts should not be painted with colours below a 45% LRV rating, as darker coatings can increase the risk of cracking or distortion in structural timber.

Refer to page 3 of the Prolam Coating Requirements for further information.

To maintain Prolam glulam posts, beams, and other exposed structural timber products, refer to the Prolam Coating Guidelines for full instructions on preparation, application, and recoating intervals. For additional guidance, refer to the manufacturer's coating instructions on the product packaging. 

No. Splits or openings along a glue line in Prolam glulam do not necessarily mean delamination has occurred. They are often caused by natural checking as the engineered timber responds to changes in moisture. In larger timber sections, these checks commonly occur along glue lines where the timber fibres are interrupted and can be mistaken for delamination.

Delamination is the separation of the timber from the adhesive bond. If you look into the opening, natural checking will typically show rough or torn wood fibres, whereas delamination will appear as a smooth, flat separation along the glue line. You can also check the depth of the opening by gently inserting a thin card or feeler gauge.

If delamination is suspected, contact the Prolam technical team for assessment and advice.

It is important to only use fixings for Prolam glulam timber that have been specified by the engineer's specification or PS1. Ensure galvanised or stainless options are selected depending on indoor/outdoor use and timber treatment. Don't fasten too close to edges or ends.

Common suppliers we recommend are MiTek, Pryda, Simpson Strong-Tie or SPAX.

View our fixing details here.

For MCA H3.2–H5 treated glulam timber, Prolam recommends a minimum of 304 stainless steel fasteners, nails, and screws for all exterior or exposed structural timber applications. This is because MCA treatment can accelerate corrosion in standard steel fixings, and stainless steel provides the durability needed to maintain structural integrity over the long term.

Learn more about fixing to MCA treated timber here. 

Apart from our glulam exposed truss, pergola and PLX bracing solutions which include fixings and connections, Prolam does not sell fixings. However, you can find our fixing recommendations for use with our products here.

You can purchase these at your local trade store, e.g. PlaceMakers, Carters, Mitre 10, ITM, Bunnings, BuildLink etc.

Fentec post caps are available from most timber merchants. 
Visit the Fentec website to view available post cap options and locate your nearest stockists.

For custom-sized post caps, we recommend speaking with a local joiner.

Yes, you can drill or notch a Prolam glue laminated beam but only if it has been specifically detailed by the engineer or using the Prolam Specifier. Unapproved holes and notches can void compliance and compromise structural performance of engineered timber.

Ensure holes are small and drilled in the middle third of the span, centred vertically and never at the beam ends or where supports or fixings are required

View our design and install guide here.